 |
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
| Datasheet File OCR Text: |
| 500~600W Parallel (N+1) With PFC Function Features : AC input 180~260VAC only PF> 0.98@ 230VAC SCP-600 series Protections: Short circuit / Overload / Over voltage / Over temperature Built in remote sense function Built-in remote ON-OFF control Built-in power good signal output Built-in parallel operation function(N+1) Can adjust from 20~100% output voltage by external control 1-5V Forced air cooling by built-in DC fan 3 years warranty SPECIFICATION ORDER NO. SAFETY MODEL NO. DC VOLTAGE RATED CURRENT CURRENT RANGE RATED POWER OUTPUT VOLTAGE ADJ. RANGE LINE REGULATION LOAD REGULATION VOLTAGE RANGE FREQUENCY RANGE POWER FACTOR INPUT EFFICIENCY (Typ.) AC CURRENT INRUSH CURRENT (max.) LEAKAGE CURRENT (max.) OVERLOAD PROTECTION OVER VOLTAGE OVER TEMPERATURE WORKING TEMP. WORKING HUMIDITY ENVIRONMENT STORAGE TEMP., HUMIDITY TEMP. COEFFICIENT VIBRATION SAFETY STANDARDS WITHSTAND VOLTAGE SAFETY & EMC (Note. 5) Note. 4 SCP-600-05 SCP-600-09 SCP-600-12 SCP-600-15 SCP-600-18 SCP-600-24 SCP-600-36 SCP-600-48 SCP-600-60 600S-P005 5V 100A 0 ~ 100A 500W 600S-P009 9V 66A 0 ~ 66A 594W 100mVp-p 600S-P012 12V 50A 0 ~ 50A 600W 120mVp-p 600S-P015 15V 40A 0 ~ 40A 600W 150mVp-p 600S-P018 18V 33.3A 0 ~ 33.3A 599W 180mVp-p 600S-P024 24V 25A 0 ~ 25A 600W 240mVp-p 600S-P036 36V 16.6A 0 ~ 16.6A 597W 360mVp-p 600S-P048 48V 12A 0 ~ 12A 576W 480mVp-p 1.0% 0.5% 0.5% 600S-P060 60V 10A 0 ~ 10A 600W 500mVp-p 1.0% 0.5% 0.5% RIPPLE & NOISE (max.) Note.2 100mVp-p 3.0% Typical adjustment by potentiometer 20%~100% adjustment by 1~5VDC external control 1.0% 1.0% 1.0% 1.0% 1.0% 1.0% VOLTAGE TOLERANCE Note.3 1.5% 0.5% 1.0% 180 ~ 260VAC 47 ~ 63Hz >0.98 / 230VAC 80% 5.0A / 230VAC 60A / 230VAC 3.5mA / 240VAC 105 ~ 115% rated output power Protection type : Current limiting, delay shut down o/p voltage, re-power on to recover 110 ~ 135% Follow to output set up point Protection type : Shut down o/p voltage, re-power on to recover >100 / measure by heat sink, near transformer Protection type : Shut down o/p voltage, recovers automatically after temperature goes down -20 ~ +65 (Refer to output load derating curve) 20 ~ 90% RH non-condensing -20 ~ +85 10 ~ 95% RH 0.04% / (0 ~ 50 ) 10 ~ 200Hz, 2G 10min./1cycle, 60min. each along X, Y, Z axes UL60950, TUV EN60950-1 approved I/P-O/P:3KVAC I/P-FG:1.5KVAC O/P-FG:0.5KVAC / 70% RH 82% 84% 85% 86% 89% 89% 0.5% 0.5% 0.5% 0.5% 0.5% 0.5% 0.5% 0.5% 0.5% 0.5% 0.5% 0.5% SETUP, RISE, HOLD UP TIME 500ms, 250ms, 16ms at full load 260 ~ 370VDC see the derating curve 90% 90% I/P-O/P, I/P-FG, OP/FG:100M Ohms / 500VDC / 25 EMI CONDUCTION & RADIATION Compliance to EN55022 (CISPR22) class A Compliance to EN61000-3-2,3 HARMONIC CURRENT EMS IMMUNITY POWER GOOD SIGNAL SPECIAL FUNCTION COOLING MTBF DIMENSION PACKING ISOLATION RESISTANCE Compliance to EN61000-4-2,3,4,5,6,8,11, light industry level, criteria A Open collector of NPN transistor DC Voltage Adj., remote sensing, remote control, parallel operation(refer to control terminal instruction manual) By fan, >20% load or >50 fan on ) 74.9K hrs min. MIL-HDBK-217F(25 290*120*68mm (L*W*H) 1.9kg ; 8pcs / 22kg / CARTON OTHERS NOTE 1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature. 2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor. 3. Tolerance : includes set up tolerance, line regulation and load regulation. 4. Current limiting 3 times(1.5s,3.0s,5.0s)Then intelligent auto recovery before shut down 5. The power supply is considered a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meets EMC directives. File Name: SCP-600-SPEC 2008-05-06 500~600W Parallel (N+1) With PFC Function Mechanical Specification SCP-600 series Unit:mm 18.5 9.2 11 41 10 190 10 39 30 CN1 38 68 1 23 #6-32-4 M3(NUT)X3H-4 12345678 LED Vadj NEG- 15 POS+ 120 9 251 30 M3(NUT) 3H-4 AIR FLOW AC INPUT DC OUTPUT POS M6 NEG 26.5 17 Terminal Pin No. Assignment Pin No. 1 2 3 Assignment AC/L AC/N FG Control terminal Pin No. Assignment (CN1) : Dinkle 51HDBC-O8P or equivalent Pin No. 1 2 3 4 Assignment VS+ VSVCI VCO Pin No. 5 6 7 8 Assignment Mating With PG PAR Dinkle 51SDB-O8P or equivalent GND INH Derating Curve Ta=25 100 800 80 OUTPUT POWER (W) 700 600 550 400 450 300 LOAD (%) 60 40 20 -20 -10 10 20 30 40 50 60 70 90 110 140 89 BOTTOM SIDE 14 260 AMBIENT TEMPERATURE ( ) INPUT VOLTAGE (VAC) 60Hz File Name: SCP-600-SPEC 2008-05-06 500~600W Parallel (N+1) With PFC Function Control terminal instruction manual SCP-600 series LOAD LOAD LOAD LOAD VS+ VSVCI VCO PG PAR GND INH VS+ VSVCI VCO PG PAR GND INH VS+ VSVCI VCO PG PAR GND INH ON/OFF SWITCH VS+ VSVCI VCO PG PAR GND INH H:ON L:OFF USING INTERNAL VOLTAGE CONTROL REMOTE SENSING ON/OFF CONTROL BY SWITCH ON/OFF CONTROL BY TRANSISTOR Vout GOOD FAIL : LED OFF : LED ON O.V.P. 120% (Typ.) 120 100 LOAD LOAD OUTPUT VOLTAGE (%) 80 60 40 20 Non-Linear VS+ VSVCI VCO PG PAR GND INH 40V / 0.5A MAX. VS+ VSVCI VCO PG PAR GND INH DC 1-5V POWER GOOD SIGNAL OUTPUT VOLTAGE ADJUST WITH DC 1-5V 1 2 3 4 5 6 V EXTERNAL VOLTAGE (DC) LOAD LOAD VS+ VSVCI VCO PG PAR GND INH VS+ VSVCI VCO PG PAR GND INH VS+ VSVCI VCO PG PAR GND INH VS+ VSVCI VCO PG PAR GND INH VS+ VSVCI VCO PG PAR GND INH VS+ VSVCI VCO PG PAR GND INH PARALLEL OPERATION WITH REMOTE SENSING PARALLEL OPERATION WITHOUT REMOTE SENSING File Name: SCP-600-SPEC 2008-05-06 |
Price & Availability of SCP-600
 |
|
|
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
| [Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
|
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |